Descaling the appliance ��������������������������������������� 10 14.8 Replacing the power cable ����������������������������������� 10 - Regularly activate the safety valve to prevent 14.9 Checking the earth conductor �������������������������������� 10 it from becoming blocked, e.g. by limescale deposits. | SHC 10 | SHC 15 www.stiebel-eltron.com...
Any other use beyond that described shall be deemed inappropri- Injury ate. Observation of these instructions and of instructions for any accessories used is also part of the correct use of this appliance. Electrocution Burns (burns, scalding) www.stiebel-eltron.com SHC 10 | SHC 15 |...
See type plate on the appliance. = Cold. On this setting, the appliance is protected from frost. The tap, water lines and safety valve are not pro- tected. MAX = Highest selectable temperature | SHC 10 | SHC 15 www.stiebel-eltron.com...
The safety valve drain must remain open to the atmosphere. f Fit a pressure reducing valve upstream of the safety valve in the cold water supply line if the supply pressure is > 0.48 MPa. | SHC 10 | SHC 15 www.stiebel-eltron.com...
INSTALLATION Installation Water connection SHC 10 GB Eltron | SHC 15 GB Eltron Material losses Carry out all water connection and installation work in accordance with regulations. Material losses The appliance may lose its function. f Never interchange the water connections.
Loud boiling noises The appliance is scaled Descale the appliance. inside the appliance. Water drips from the The safety valve is Clean / descale the valve seat. safety valve after scaled up or dirty. heat-up. | SHC 10 | SHC 15 www.stiebel-eltron.com...
Disconnect all wires from the combined temperature control- ler/high limit safety cut-out. f Drain the appliance via its connectors. f Remove the combined temperature controller / high limit safety cut-out from the flanged immersion heater. f Remove the flanged immersion heater. www.stiebel-eltron.com SHC 10 | SHC 15 |...
15.2 Wiring diagram 1/N/PE ~ 220-240 V 15.1 Dimensions and connections SHC 10 | SHC 15 Stiebel 15.3 Heat-up diagram The heat-up period depends on the degree of scaling and residual heat. For the heat-up time for a cold water supply at 10 °C and a maximum temperature setting, see the diagram.
Steel, enamelled Thermal insulation material Casing material Colour White White White White Connections Water connection G 1/2 A G 1/2 A G 1/2 A G 1/2 A Dimensions Depth Height Width Weights Weight | SHC 10 | SHC 15 www.stiebel-eltron.com...
Page 13
This will not affect warranties issued by any importers. Environment and recycling We would ask you to help protect the environment. After use, dispose of the various materials in accordance with national regulations. www.stiebel-eltron.com SHC 10 | SHC 15 |...
Need help?
Do you have a question about the SHC 10 and is the answer not in the manual?
Questions and answers