Specification; Troubleshooting - XtremeAIR Special Series Installation Manual & User Manual

Table of Contents

Advertisement

11. SPECIFICATION

Body Design
Power Rating
General Input Power
Motor Input Power
Ampere
Levels Of Speed Control
Maximum Airflow
Noise Level
Number Of Motors
Motor Type
Fan Type
Filtration Type
Illumination
Venting Size
Interference Protection
Note

12. TROUBLESHOOTING

1. If the range hood or lights does not operate after installation:
Check if the range hood has been plugged in. Make sure that all power has been turned back ON. Check if the fuse is not blown and all electrical wiring is
properly connected.
Swap out light assembly to working ones to deter mine whether it is caused by defective bulbs. See
2. The range hood vibrates when the blower is on:
The range hood might not have been secured properly on to the ceiling or wall.
Check if the motor is secured in place.
3. the blower or fan seems weak:
Check that the duct sized used is at least 6". Range hood WILL NOT function efficiently with insufficient duct size & loosely secured.
 Check if duct is clogged or if damper unit (half-circular flapper) is not installed correctly or opening properly. A tight mesh on a side wall cap unit
might also cause restriction to the air flow.
4. The lights work but the blower is not spinning at all, is stuck or is rattling.
The blower might be
The motor is defective, possibly seized - change the
5.
The hood is not venting out properly:
Make sure the distance between the stove top and the bottom of the hood is within 26" and 30" in distance.
ceiling height configurations, recommended height may not be applicable.
Reduce the number of elbows and length of ductwork. Check if all joints are properly connected, sealed, and taped.
Make sure the power is on high speed for heavy
6. The hood is noisier than normal
The duct is not secure and causes
The smaller duct size than required is being
7. Control panel is not active
Check to make sure the auto function is not on. 
Non-Magnetic 1.0 mm Stainless Steel, Satin Finish
120V/60Hz (USA & Canada standard)
158W (150W + 4x2W)
150 W each
1.3 A
4 Levels
900CFM
Approximately 1.5 – 6.0 sones or 33 – 54 dB
Single Motor
Single Chamber Ultra Quiet
Squirrel Cage blower
Heavy Duty Stainless Steel Baffle Filter
4 LED lights, 2W Maximum/each
Top 6 inches Round
Radio Frequency Interference Protected
Specification subject to change without notice.
If not, then tighten the motor in place. Check if the blower wheel is
jammed or scraping the bottom due to shipping damage. Please contact us
motor.
cooking.
vibration.
used.
replacing the light bulbs
damaged.
immediately.
Due to different
on Page 13.
Page 8

Advertisement

Table of Contents
loading

Table of Contents