Kenwood VR Series Instruction Manual page 5

For VR-305, VR-306, —
Frequency display,
input display,
Preset channel display,
Surround mode display
and KRF-V5020
Speaker indicator
MUTE indicator
Speaker selection indicators
Output channel indicators
Display
For U.S.A.
and Canada
93 ¢i¢] i?) 8) §Z iy €i5 17 18
0°
For KRF-V6020
@ POWER key -7) @ MEMORY key -
(For U.S.A. and Canada)
Use to turn the power ON/OFF.
STANDBY indicator
@ ON/STANDBY (1/0 ) key -fq)
{Except for U.S.A. and Canada)
Use to switch the power ON/STANDBY
when the POWER is turned ON.
STANDBY indicator
@ POWER key ~a
(Except for U.S.A. and Canada)
© DIMMER key -az
Use to adjust the brightness of the display.
@ BAND key -f2
Use to select the broadcast band.
@ AUTO key ~i
Use to select the auto tuning mode.
About the STANDBY indicator
Use to store radio stations in the preset
memory.
© VOLUME CONTROL knob
~G
@ PHONES jack -)
Use for headphonelistening.
@ SPEAKERS A key (KRF-6020) -(i4)
Use to turn speaker system A on and off.
SPEAKERS key
(VR-305, VR-306, VR-355, and
KRF-V5020 ) -Q
Use to turn the speakers on and off.
@ SPEAKERS B key (KRF-6020) -(4)
Use to turn speaker system B on and off.
MUTE key
(VR-305, VR-306, VR-355, and
KRF-V5020 ) -o
Use to temporarily mute the sound.
@ BASS BOOST key -a
Use to select the maximum adjustment
setting for the low frequency range.
Band indicators
Set) atures aT ACTOR
4 y Y
19
VRAKRF-V SERIES (En/KM)
PRO LOGIC
indicator
S.DIRECT indicator
AUTO indicator
MEMO. indicator
ST. indicator
TUNED indicator
MONITOR indicator
DSP indicator
3 STEREO indicator
STEREO indicator
@ VIDEO 2/MONITOR key -3)
@ SOURCE DIRECT key —(ia)
@ LISTEN MODE key -a
Use to select the listening mode.
@ SOUND key ~
Use to adjust the sound quality and ambi-
ence effects.
@ SETUP key ap
Use to select the surround sound settings.
@ MULTI CONTROL knob
Used to make a variety of settings.
@ INPUT SELECTOR knob -(ii)
Use to select the input sources.
This unit has a STANDBY indicator. When the STANDBY indicator is lit, the unit consumes a small amount of power to preserve the memory. This i is called
STANDBY mode. This mode also lets you turn the power ON using the remote control.