Kenwood VR Series Instruction Manual page 13

Loading the batteries
Operation
When the STANDBY indicator is tit, the power turns ON when you press
the POWER key on the remote control. When the power comes ON,
press the key you want to operate.
Operating range
(Approx.} Remote sensor
Model: RC-R0711
Infrared ray system
* When pressing more than one remote controt key successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
eee ee
Notes
+. The supplied batteries may have shorter tives than ordinary batteries
due to use during operation checks.
2.When the remote-controllable distance gets shorter than before,
replace both batteries with new ones.
3. Placing the remote sensor in direct sunlight, or in direct light from a
high frequency fluorescent lamp may cause a malfunction.
in such a case, change the location of the system installation to
prevent malfunction.
VA/KRF-V SERIES (En/KM}
Speaker settings
To enable you to obtain optimum enjoyment from the receiver's
listening modes, make sure to complete the speaker settings as
described below.
SETUP
MULT) CONTROL
RC-ROG0S
Turn on the receiver.
Select a speaker system.
© Use the MULTI CONTROL (TUNING/SKIP) to select the appro-
priate subwoofer setting.
@ SUBW YES: A subwoofer is connected to the receiver.
@ SUBW NO: No subwoofer is connected to the receiver.
© Press the SETUP key to accept the setting.
¢ The center speaker setting indication (CNTR) appears.
wan SAE AlT AIRAL
Livi Wii™
© Use the MULTI CONTROL (TUNING/SKIP) to select the appro-
priate center speaker setting.
@ CNTR NML (normal): An average size center egieaine is
connected to the receiver,
@ CNTR LRG (large): A large center speaker is con-
nected to the receiver.
© CNTR NO: No center speaker is connected to
the receiver.
© Press the SETUP key to accept the setting.
¢ The surround speaker setting indication (SURR) appears.
receiver.
No surround speakers are connected tothe
receiver.
z @SURR YES: Surround speakers are connected to the
@ SURR NO:
© Press the SETUP key to accept the setting.
The receiver enters the speaker volume level adjustmentmode.
ein steps & and @, indications appear only for the selected
channels of the speakers that require adjusting.-
Continued to next page