Kenwood VR Series Instruction Manual page 15

a aa
VRIKRF-V SERIES (En/KM)
PHONES MULTI CONTROL
SPEAKERS A/B (KRF-6020)
SPEAKERS, MUTE (except for KRF-6020)
VIDEO-s = AUDIO jocoe
C) . sees ere
| biter I 2 VIDEO © 8 | eee
(0 + VOLUME 'OD | ® | votume tl2s22
Input selector 55% aun [ospo
keys TUNING/SKIP+@ f é | sounp 4 ,
MUTE-""s J } MULTI Precis init +.
RC-RO0608 RC-RO711 SOUND \oo coo00
RC-RO60B RC-RO711
Use the input selector (INPUT SELECTOR (AUDIO, VIDEO))
to select the source you want to listen to.
Adjusting the tone
The input sources change as shown below:
The following adjustments are possible if the receiver is in the stereo
Selecting a source using the INPUT SELECTOR knob i :
mode.
© TUNER
6 "CD" ("cD"*) @ Press the SOUND key to select the tone mode to be adjusted.
© "TAPE" or "MD" ("TAPE"*)
@ "PHONO"("PHONO"*) BASS: Select this to adjust the low frequency range.
@ "VIDEO" ("VCR1"*) (Press the SOUND key once.)
@ "VIDEO2" ("VCR2"*) TREB: Select this to adjust the high frequency range.
@ "DVD 6ch" (Press the SOUND key twice.)
Selecting a source using the AUDIO key Pm
on the remote control (RC-R0608)
ve
ul 7 c [- }
+ L cuss
eo "cb" ("cD"*)
@ "TAPE" or "MD" ("TAPE"*)
© TUNER
@ "PHONO"("PHONO"*) @ Use the MULTI CONTROL (TUNING/SKIP) to adjust the sound
quality. .
Selecting a source using the VIDEO key "The bass and treble levels are adjustable from -10 to +10 in 2 step
on the remote contro! (RC-RO0608) increments.
@ "VIDEO1" ("VCR1"*) ¢ The adjustment item is displayed for approximately 8 seconds.
[ 6 "VIDEO2" ("VCR2"*) ¢ if you used the remote control (RC-RO608) to perform the above
© "DVD 6ch" setting, press the VIDEO key at this point to turn off the remote
control's own adjustment mode. In this case, the input source is not
switched.
¢ When selecting an input source by using the remote control (RC-
RO711), press the desired input selector key.
*® "VIDEO 2" can be selected as an input source only if the VIDEO 2/
MONITOR setting is "VIDEO 2". -
Once-touch low frequency emphasis (bass boost)
* Once setup codes are registered inthe remote control (RC-RO608),
Example: if you register a VCR at the VIDEO 1 jacks, "VCR" appears '
instead ot "VIDEO 1°. RC-—) Press the BASS BOOST key.
¢ When using the remote control (RC-RO608) after initial setup, any
inputs that have not been registered with a setup code are deleted
from the cyclic list. AC-Ca)
The INPUT SELECTOR on the front panel of the receiver always
cycles through all inputs.
* Press the key once to select fhe maximum (+10) low frequency
emphasis setting.
¢ This key does not function when the receiver is in the sound quality
or ambience effects adjustment mode.
Start playback from the selected source. . Switching back to the previous setting
P the BASS BOOST key again.
Use the VOLUME CONTROL (VOLUME) to adjust the on —
vorume.