Kenwood VR Series Instruction Manual page 11

Connecting the speakers
© Strip coating.
CRE O-
Front Speakers A
Except for The KRF-
V6020 is equippedwith
one-touch speaker ter-
minals. Theyare arranged
in the same manner as
the speaker terminals of
the KRF-6020. Refer to
the instructions on
making connections to
the KRF-6020 when
making connections to
the VR-306/ VR-305/VR-
355 and KRF-V5020.
Right
Use the FRONT
SPEAKERS 8
terminals if you
want to connect a
second front
speaker system.
(VR-306, VR-305,
VR-355 and KRF-
V¥5020 are not
Powered
subwoofer equipped with Right Left
SPEAKERS B Surround Speakers
terminal.) (Be sure to connect both
surround speakers)
VR/KAF-¥ SERIES (En/KM}
* @ Push lever. @ Strip coating.
Ee O-
© Insert cord.
—|
* Never short circuit the + and — speaker cords.
¢ If the left and right speakers are connected inversely or the speaker
cords are connected with reversed polarity, the sound will be
unnatural with ambiguous acoustic imaging. Be sure to connect
the speakers correctly.
Speaker impedance
After confirming the speaker impedance indications printed on the
rear panei of the receiver, connect speakers with matching imped-
ance ratings. Using speakers with a rated impedance other than that
indicated on the rear panel of the receiver coutd result in malfunctions
or damage to the speakers or receiver.
FRONT SPEAKERS
CENTER SPEAKER
SURROUND SPEAKERS
PRE OUT connections
This receiver has additional preout jacks. These can be used for
various purposes, but will need to be connected to an external power
ampiifier as shown in the example below.
Surround ©
Speakers
Power amplifier
Powered
Subwooter
Power amplifier
* The VR-305, VR-306, VR-355 and KRF-V5020 is equipped with a
SUBWOOFER terminal only.
Connecting a speaker cord directly to a PRE OUT jack will not
produce any sound fromthe speaker. - :
* To use the PRE OUT jacks, press the SPEAKERS A key to the on
position (the SPEAKERS key in the case of the VR-305, VR-306, VR-
355 and KRF-V5020)