Kenwood VR Series Instruction Manual page 10

Connecting the system control
SYSTEM CONTROL SYSTEM CONTROL
| cord |
GLB (08)
= ae
ayer Contec, Ses |
SYSTEM CONTROL SYSTEM CONTROL
switch
switch
Except for KRF-V6020 KRF-V6020
EXAMPLE: [XS8] mode connections
The underlined portion represents the setting of the system control
mode.
[St16] (XS8]
[S16] (XS) [X88] DXA)
[SL16) [XS] [XS8}
[XS]
SYSTEM
CONTROL
cord
EXAMPLE: [SL16] mode connections
The underlined portion represents the setting of the system control
mode.
[S16] [XS8]
SYSTEM
CONTROL
cord
($L.16] [XS} [XS8] [XR]
[SL.16] [XS] [XS8]
In order to take advantage of the system control operations, the
components must be connected to the correct jacks. To use a cD
player it must be connected to the CD jacks. To use a cassette deck
(or MD recorder) it must be connected to the MD/TAPE jacks. When
using more than one CD player (etc.) only the one connected to the
specified jacks may be connected for system control.
* Some MD players are not system control compatible. You cannot
make systern control connections to this kind of equipment.
VRIKRF-V SERIES {En/KM)
ee
Notes
4. [SL16] equipment cannot be combined with [XR], [XS]. and [XS8]
equipment for system operations. If your equipment consists of this
kind of combination, please do not connect any system control
cords. Even without system control cords, normal operations can
be carried out without effecting performance.
. Be sure the system control piugs are inserted all the way in to the
system control terminals.
Do not connect a system control cord to a cassette deck con-
nected to the MONITOR jacks.
SYSTEM CONTROL OPERATIONS
Remote Control
Lets you operate this unit with the system remote supplied with the
receiver.
Automatic Operation (except [XR] equipment)
When you start playback from a source component, the input selector
on this unit switches to that component automatically.
Synchronized Recording (except [XR] equipment)
Lets you synchronize recording with the start of playback when
recording from CD, MD or analog discs.
SWITCHING FROM [SL16] TO [XS8]
You can easily change the system control mode by adjusting the
position of the SYSTEM CONTROL switch on the rear panel.
Do this operation after completing ail connections.
For [SL16] <a> For [XS8] For [SL16] <u> For [XS8]
S16 as) (ss) SLi6 #
«xs8)
Except for KRF-V6020
KRF-V6020
© This operation will not effect items stored in.the memory.
e After switching the system control mode, turn the power off and
unplug the power cord from the wall outlet, then plug it back.
Aah ogoeoniy) setup codes for KENWOOD audic components"
0608 only)
* Once you finish making the system connections, be sure toregister the
appropriate setup code for each component. rc-—Q
e Ifyou own remote controllable KENWOOD audio components that are
not compatible with system control (or cannot be combined with your
other system contro! components), registering the setup code enables
you to control those components using the remote control supplied
with this unit (without connecting system control cords). To register
setup codes for your remote controllable KENWOOD audio compo-
nents, see "Registering setup codes for other components'.
rc-Q