Kenwood VR Series Instruction Manual page 22

Resetting the Microcomputer
For U.S.A. and Canada
Amplifier
No sound from the speakers.
The standby Indicator bilnks and sound is
not output.
Sound is not output from one of the speakers.
Sound is not output from the surround
speakers and/or the center speaker, or their
sound Is very small.
Radio stations cannot be received.
Interference.
A station which was preset cannot be re-
ceived by pressing the corresponding nu-
meric key.
Remote control unit
Remote control operation ts not possible.
VA/KRF-V SERIES (En/KM)
For other countries
factory.
¢ The speaker cords are disconnected.
© VOLUME is set to the minimum position.
¢ MUTE is ON.
* The SPEAKERS switches are set to OFF.
¢ Speaker cords are short-circuited.
«The speaker cord is disconnected.
¢ The surround speaker cords and/or the center
speaker cord is disconnected.
¢ A surround mode has not been engaged.
* The surround and/or center volume controls
are set to the minimum level.
¢ The audio cord from the turntable ts not con-
nected to the PHONO jacks.
The turntable is not grounded.
No antenna is connected.
¢ The broadcast band is not set properly.
*The frequency of the desired station is not
tuned.
*Noise due to interference from an electric
appliance.
« Noise due to a nearby TV set.
The preset station belongs to a frequency that
cannot be received.
* The preset memory was cleared because the
power cord had been unplugged for a long
period of time.
« Batteries are exhausted.
© The remote control unit is too far away from the
main system, controlling angie is too large, or
there is an obstacle between the receiver and
the remote.
# The audio cords and system control cords are
not connected properly.
¢ No software is loaded in the source-compo-
nent.
¢ An attempt is made to play a tape which is
being recorded in the cassette deck.
Connect them properly referring to "Connect-
ing the speakers" ~fid
® Adjust the volume to a proper ievel.
e Turn OFF the MUTE. ~ Oe)
¢ Set the SPEAKERS switch(es) toON. —-G&
¢ Turn the power off, eliminate the short-circuit-
ing, then turn on the power again. ~fy)
Connect it properly referring to "Connecting
the speakers".
« Connect it properly referring to "Connecting
the speakers".
# Select a surround mode.
# Adjust the speaker levels using the test tone.
~
¢ Insert the audio cord plugs securely into the
PHONO jacks.
¢ Connect the grounding wire to the GND termi-
nal on the rear panel.
# Connect an antenna.
Set the broadcast band properly.
* Tune the frequency of the desired station.
~!
e Install the outdoor antenna away from the
road.
© Turn off the power to the appliance.
e Install the receiver farther away from the TV.
* Preset a station with a receivable frequency.
¢ Preset the station again.
® Replace with new batteries. -f -
* Operate the remote control unit within the
controllable range.
* Connect properly referring to "Setting up the
system". "-
* Place software in the source component you
want to play. : .
¢ Wait until recording has completed.