Advertisement
HANDS-FREE TRANSMITTER PROGRAMMING
This system can code learn up to 4 different transmitters. All transmitters must be learned at one time.
1. Turn ignition switch on and off 3 times leaving it on the 3
2. Push the Valet/Programming button for 5 seconds until the in-dash LED flashes 5 times.
3. Press the Button on the hands-free transmitter once – The dash LED will flash once to confirm
programming. Repeat this step within 5 seconds for up to 3 additional transmitters.
4. Turn off ignition.
NOTE!: YOU MUST TURN OFF ALL REMOTES BERORE PROGRAMMING ANY FEATURES!
OPERATION INSTRUCTIONS FOR TURNING OFF REMOTE.
1. Turn Key to the ON position
2. Within 10 seconds press the Valet/Program button 5 times. The System LED will flash 3 times to confirm
you are in programming mode.
3. Now press the Valet/Program Button the number of times that corresponds the option in the list below. The
System LED will flash once each time you press the Valet/Program button.
4. Once you are at the desired feature, momentarily press the Button on the Remote Transmitter to change
the option. The System LED will flash ONCE to turn the feature ON, or flash TWICE to turn the feature
OFF.
Feature
1.
2.
3.
4.
5.
6.
Restore All Options:
To restore all features to the Factory Default ("ON" column) position, follow steps 1 & 2 above, then
immediately press the button on the remote transmitter one time. The system LED should flash 4 times and
the programmable features 1-6 will operate as in the "ON" default column listed above.
FEATURE PROGRAMMING
Feature Description
Auto Lock With Ignition
Unlock when disarmed
Horn Chirp for Arm/Disarm
Single/Double Unlock
Pulse
1 or 3 Second Lock Pulse
Wire #9 Function
rd
time. (on/off, on/off, on) LED will Flash 3 times.
ON (Default)
LED
ENABLED
1
ENABLED
1
DISABLED
1
1 Pulse
1
1 Second
1
30 Sec
1
Domelight
OFF
LED
DISABLED
2
DISABLED
2
ENABLED
2
2 Pulses
2
3 Second
2
Factory Disarm
2
SEE
Advertisement
