Download Print this page

CrimeStopper CS-8050 Installation & Operating Instructions Manual page 5

Hands-free keyless entry / immobilizer system

Advertisement

How the System Works: (Hands-Free Mode)
As you turn your Ignition OFF and leave your vehicle, the system will automatically arm. The tiny hands-free
remote transmitter on your key chain emits a low power signal every few seconds. As you return to your
vehicle (approximately within 15-30 feet), the immobilizer system will "pick up" the signal from the tiny remote
and disarm/unlock your vehicle. To operate in hands-free mode, the remote transmitter must be turned ON.
Turning the Remote ON (Start sending signals):
Press and hold the remote button for about 5 seconds until LED on remote flashes once (Ignore first double
flash). The remote is now ON and will send a signal every few seconds. If you remain near your vehicle with
the remote arm is will never arm. (Note: The remote is OFF when this system is shipped from the factory to
save battery life.)
Arming:
When exiting the vehicle, (Ignition turned off) there will be a 15-second delay before the system
AUTOMATICALLY arms. Again if your remote is turned on and you are within range your vehicle may not arm
because it is receiving signal from the remote. The In-Dash LED will begin to flash rapidly after the Ignition is
turned off as a visual indication that the countdown has begun.
Immobilizer circuits will become active, the doors will lock and the LED will now flash slowly.
NOTE: If your remain in or near your vehicle, the system will not arm because it is receiving
signals from the hands-free transmitter.
Disarming: (Hands Free Mode)
As you return to your vehicle (approximately within 15-30 feet), the immobilizer system will "pick up" the signal
from the tiny remote and disarm/unlock your vehicle. Dome light will also turn on if this optional feature is
installed.
Manual Arming/Disarming:
If desired, this system can be armed and disarmed by pressing the button on the remote. YOU MUST HAVE
THE REMOTE OFF WHEN MANUALLY ARMING AND DISARMING. When exiting the vehicle, (Ignition
turned off) there will be a 15-second delay before the system AUTOMATICALLY arms or you can arm it by
pressing the button on the remote before the 15 second countdown ends. When returning to your vehicle
press the button on your remote to disarm. Remember to turn your ignition on within 15 seconds or the
system will try to arm again. See "Active Re-arm" below
OPERATING INSTRUCTIONS
After the delay, the system will arm.

Advertisement

loading