Advertisement
All touchscreen display adjustments made through the OSD are automatically memorized as soon as they are entered.
This feature saves you from having to reset your choices every time the touchscreen display is unplugged or powered off and on. If there is a power failure, the
touchscreen display settings will not default to the factory specifications.
OSD and Power Lockouts
Press and hold the "Menu" and "Down" buttons for two seconds to enable/disable the OSD Locking feature. When the OSD Locking is enabled, pressing any of the
Menu, Up, Down, or Select keys will have no effect on the system.
Press and hold the "Menu" and "Up" buttons for two seconds to enable/disable the Power Locking feature. When the Power Locking is enabled, pressing the power
switch will have no effect on the system.
Temperature Control
The monitor contains a thermal sensor that provides the user with real-time temperature readings. This reading can be found by opening the OSD menu:
Information ► System Temperature. . If the monitor reaches the temperature trigger point, it will turn on the internal fans with different speed to dissipate heat
until the internal temperature is back to 30
Temperature Trigger point
30 – 45 ° C
1
45 – 50 ° C
2
50 – 55 ° C
3
55 – 70 ° C
4
If the temperature exceeds 60
If the display internal temperature is not reduced below 65
damage.
C. If the temperature continues to rise and reaches 60
°
Shielding fans x2
20%, 3100rpm
50%, 4600rpm
80%, 7800rpm
100%, 10000rpm
, the following icon will appear in the Main Menu. This will indicate that the Thermal Protection Mode is active.
° C
C, the monitor will enter into Thermal Protection Mode.
°
, the display will automatically turn off 60 seconds to prevent permanent
° C for 5 minutes
User Manual: ET1099L Touchscreen
UM600770 Rev A, page 16 of 30
Advertisement
