Table of Contents
Advertisement
FRONT PANEL FACILITIES
(San
ce ence cs oc oo
@) POWER STANDBY/ON switch/indicator
This is the switch for electric power.
ON wee
eae When set to the ON position, power is supplied and the
unit becomes operational.
STANDBY
.. When set to STANDBY position, the main power flow is
cut and the unit is no longer fully operational.
A minute
flow of power feeds the unit to maintain operation
readiness.
The STANDBY indicator lights when the power is STANDBY, and goes
out during ON.
@ MULTI ROOM & SOURCE button (See page 36)
Use in combination with the separately sold MR- 100 Multi-Room remote
control unit.
When this button is on, the source selected with the INPUT SELECTOR
at that time is set to the Sub room function. The selected sub-function's
sound is output through SUB ROOM SPEAKERS, and the video signal
is output through the MULTI-ROOM & SOURCE VIDEO OUT jack. If
you install speaker systems connected to the MULTI-ROOM SPEAKERS
terminais in a different room, you can enjoy different sources in two
different rooms with a single main unit.
@ AUTO SOURCE CONTROL,
MEMORY
buttons
(See page 35)
AUTO SOURCE CONTROL
1, 2:
These buttons are for memorizing and recalling your current settings.
Both 1 and 2can be used to memorize settings. If you connect another
component, such as a CD player, to the CONTROL OUT jack on the
rear panel, the signals to switch
power
on and start piay are also
transmitted.
MEMORY:
Use when memorizing settings to an AUTO SOURCE CONTROL button.
® Display section (see page 22)
@© STATION CALL (RANDOM 30 CH) buttons
* These buttons are used to preset and recall desired broadcasting
stations. You can also preset AUTO/MONO
button settings.
®@
Station call operation example:
If you press the [+2] button:
* Once — station 2 is selected.
* Twice — station 12 is selected.
* Three times — station 22 is selected.
NOTE:
Pressing the STATION CALL buttons when a component other than
TUNER is selected causes the INPUT SELECTOR setting to switch to
TUNER.
* They are also used when performing direct access tuning.
© SURROUND MODE buttons (See pages 6, 32)
@ JOG MODE indicators
The indicator for the mode that can currently be operated by the JOG
dial lights. If it is not the mode you want to operate, switch to the desired
mode with the JOG MODE button (@).
@) Remote sensor window
@ INPUT ATT button
Use this when there is distortion due to excessively high input signal
level. When this is switched ON, — 10 dB attenuator operates, and the
INPUT ATT indicator in the display section lights.
@® ACOUSTIC/ENHANCER MEMORY, SELECT buttons
ACOUSTIC/ENHANCER
MEMORY:
Use to operate acoustic memory and enhancer memory. See page 34.
ACOUSTIC SELECT:
Use this to store desired sound quality settings in memory. Also use
it to recall memorized sound quality settings from memory. For further
details concerning memory operation, refer to page 34.
ENHANCER SELECT:
Use this to store a desired enhancer effect in memory, and to recall a
desired
enhancer
effect.
For further details
concerning
memory
operation, refer to page 34.
When the enhancer has been memorized, then the enhancer will be
automatically switched ON when this button is pressed.
18
<ARB1371>
Advertisement
Table of Contents
