Table of Contents
Advertisement
Speakers Connection
* Front L, R speakers
* Front center speaker
* Rear L, R speakers
When connecting speakers to the FRONT SPEAKERS
8 terminals, the procedure is the same as that used
for connecting speakers to the FRONT SPEAKERS A
terminals.
NOTE:
Do not allow any of the cord's conductors to protrude
fram the terminals or touch any other conductors.
Malfunctioning
or breakdowns
may occur
when
conductors come into contact with each other.
Front speaker impedance
Set the IMPEDANCE SELECTOR switch to
the nominal impedance of your speakers.
ie, gee
Hey
{
i
AOR B; 402 TO LESS
la
THAN 82
AANDB;89T0 160
NOTE:
° /f you have one pair of speakers only,
connect it to front speaker terminals A
or B.
* Position HIGH: when using one pair of
speakers of 8 2 to 16 2.
* Position LOW: when using one pair of
speakers (42 to 8 2) or two pairs of
speakers (8 2 to 16 2 for each speaker).
Center speaker impedance
Connect
center speaker system with a
nominal impedance of 8 2.
Rear speaker impedance
Connect
rear speaker systems
with
a
nominal
impedance
of between
8 and
16Q.
NOTE:
Be sure to observe speaker polarity.
10 mm
@ Release lever.
CENTER
CONNECTION CHART
@ Loosen cap.
@® Insert wire.
;@) Tighten cap.
15
<ARB1371>
Advertisement
Table of Contents
