Table of Contents
Advertisement
REMOTE CONTROL
OPERATING OTHER COMPONENTS
This remote control unit can be used to operate some functions of
Pioneer
SR marked VCRs, LD players, TV sets, CD players, tuners,
cassette decks, and digital audio tape decks.
OEE
EH
REMOTE CONTROLLING
OF ANY OTHER OF
YOUR AUDIOVISUAL COMPONENTS VIA THIS
UNIT REQUIRES:
1. All components
must be remote
controllable
(have a sensor
window on the front panel) to receive direct command from this
1
unit, upon successful
learning of those commands
by this
programmable unit or,
2. All units must have remote control jacks (IN/OUT) on the rear
panel and be correctly connected to the receiver according to
the diagram on page 24.
When operating components other than the receiver:
1. Press the CONTROL MODE buttons for the component you want
to operate.
2. Press the operation button.
m
>.
[i
Q > 4
Shaded WH
buttons do not operate in the selected CONTROL
MODE.
VCR 1 operation
(With VCR 2, even if you press an operation button, no signal is
output. Preset or program and use.)
POWER button:
Switches VCR power ON/OFF.
REC button:
Selects the recording mode.
Power cman
econmana
«ta
= (REW)
button:
Co]
9
@
CY
Rewinds the tape and allows picture search.
aes
hme
(FF) button:
YfLLY
an
CFA
(DZ
Rapidly advances the tape and allows picture search.
Wi
i
(PAUSE/STILL) button:
Sets pause and still picture.
(o] [>]
m=
(STOP) button:
TV/VCR
SMLECT
Tv
FUNC
Stops
tape
transport.
>
(PLAY) button:
Selects playback.
TV/VCR button:
This button can be used only for VCRs with a TV/VCR selector.
Toggles the antenna output between TV and VCR.
DISP (DISPLAY) button:
Switches TV screen display ON/OFF.
1—12 buttons:
Use to call up channels.
CH A button:
Shifts channels in ascending order.
CH V button:
Shifts channels in descending order.
F
>
Qo >
4
41
<ARB1371>
Advertisement
Table of Contents
