Table of Contents
Advertisement
FRONT PANEL FACILITIES
DISPLAY SECTION
aans — TONE —TRESLE
@® Level/Tone meters
The level meter is usually displayed. {f the input level is too high, the
display switches, and the OVER LOAD indicator lights.
During Tone control operation, the display switches accordingly.
Character display/Balance meter
* Character display indicates such information as function, received
frequency, station name, acoustic memory, and enhancer memory,
etc.
* Front and rear left/right balance is indicated. This is displayed during
balance adjustment,
after which
indications return to character
display.
Top is front.
Bottom is rear.
©) DSSS indicator
Lights when the DSSS button is ON.
@) DIRECT indicator
This lights when the Direct mode is switched ON.
© TAPE 2 indicator
Lights when the TAPE 2 MONITOR button is in the ON position.
© SURROUND MODE indicators
These display the selected surround mode. When all indicators are out,
surround is OFF.
@ Meter mode indicator
indicates the display modes mentioned
in @).
@® SPEAKERS indicators
Shows which speaker system (or systems) are switched ON.
@ INPUT ATT indicator
This tights when the INPUT ATT button is switched ON.
22
<ARB1371>
¢ Tt oy erect)
So VES aoe
SURROUND MOOE
Cheead
~-
--
(Usmecr]
Difescey somncne
Kha
woes La one)
eee
nm
(ereRec)
. Seen
ron .
Cowan
(crumcx]
mone
NTONM
wom noma
Com]
(aces) Cone)
(eo)
[ronan] (eronc]
nh
:
PEC
BEL
@® REC selector indicators
© The recording source selected with the REC SELECTOR button is
usually displayed.
® Station call no./Delay time/Surround effect/Enhancer level display
¢ Usually, the STATION indicator and ''ch'' light to display the station
call number.
¢ When adjusting surround delay time, the DELAY indicator and ms
light to display delay time.
* When adjusting surround effect level, the EFFECT indicator lights,
and effect level from 5 to 100 is displayed.
¢ When adjusting enhancer level, enhancer level from ~— 50 to 50 is
displayed.
© Tuning indicators
FM MONO:
This lights when you select MONO with the AUTO/MONO
button. When this indicator is tit, reception of FM stereo
broadcasts is also monaural.
STEREO:
When the FM MONDO indicator is out (auto stereo mode},
this lights when receiving an FM stereo broadcast.
TUNED:
Lights when a station is tuned.
@) CENTER MODE indicators
These display the center mode (NORMAL, WIDE, PHANTOM) during
THEATER or DOLBY PRO LOGIC SURROUND.
With DOLBY 3CH LOGIC, you can select NORMAL
or WIDE; but you
cannot select PHANTOM.
Warning indication:
Display section indicators will flash to indicate that operation is not
possible in a particular situation when you press a button. With Multi-
Room & Source, the button itself flashes.
Advertisement
Table of Contents
