Checking For Contact; Inserting The Graphics Card Into The Chassis - EK Pro RTX A5000 Rack User Manual

Gpu water block

Table of Contents

CHECKING FOR CONTACT

If necessary, temporarily remove the water block to check for uniform

surface contact between the block and components. Pay special

attention to the VRM section of the graphics card. Check whether

the water block makes contact with the intended integrated circuit.

Then repeat Steps from the previous section to re-attach the block.

In case you fail to obtain good contact, please check

again or contact our support service at

https://www.ekwb.com/customer-support/.

Carefully lift your graphics card with the installed water block and

insert it into your PC's motherboard PCIexpress expansion slot.

Please keep in mind that your graphics card is heavier than before it

was equipped with the water block.

You need to be very careful when handling the

graphics card. Avoid all unnecessary manipulation

of the water block assembly that might damage your

card or water block.

- 12 -

Table of Contents

Do you have a question about the Pro RTX A5000 Rack and is the answer not in the manual?