Faults And What To Do About Them - NEFF V6540X3GB Instruction Manual And Installation Instructions

Faults and what to do about them

en
Faults and what to do about them
Fault
Programme does not
start
The maximum spin
speed cannot be set.
The water is not
Drained.
Detergent residues in
the detergent drawer.
Water is not flowing in. The mains plug is not correctly plugged
Intense vibrations dur-
ing spinning.
Washer-dryer fills with
water and continu-
ously drains it away.
No water can be seen
in the drum.
46
Possible cause
The Start/Pause I button has not
been pressed.
A delayed start time has been selected.. Washer dryer starts on completion
Power cut.The delayed start time that
was selected has been cleared.
The door is not properly closed.
Plug not inserted properly into socket.
The maximum spin speed depends on
the programme selected.
Drain hose is twisted..
Detergent pump is blocked.
Damp or lumpy detergent.
in.
The door is not properly closed.
The tap is not turned on.
The filter in the water supply hose is
blocked.
The water supply hose is pinched or
kinked.
The washer-dryer is not correctly lev-
elled.
The transport safety bolts have not been
removed.
Drain hose fitted too low.
Not a fault.
Remedial Action
Press the Start/Pause I button.
ofthe delay period. Change the "fin-
ished in time" if necessary.
Reselect the delayed start time or
startthe programme immediately.
Press the Start/Pause I button.
Close the door.
Insert plug correctly
Change programme as required.
Fit the Drain hose correctly.
Clean the Drain pump .
Clean and dry the detergent drawer .
Use the measuring aid for liquid
detergent.
Plug in the mains plug correctly.
Close the door.
Turn on the tap.
Clean the filter in the water supply
hose.
Check the water inlet hose.
Level the washer-dryer .
Remove the transport safety bolts .
Fit the Drain hose correctly.
During certain programmes the
water level is below the visible
range.