Table of Contents
Advertisement
Faults and what to do about them
en
Fault
The fabric softener is
not completely flushed
in or too much water
remains in the com-
partment.
The laundry is not
dried.
No display on the dis-
play panel.
The door cannot be
opened.
Emergency release
If you cannot correct a fault yourself (switching on/off) or a repair is required:– Turn the programme selec-
tor to Off and unplug the mains plug from the socket.– Turn off the tap and call the after-sales service –>
page 24.
48
Possible cause
The fabric softener compartment insert
is not correctly attached or is blocked.
The tap is turned off.
The load is too large.
The drying time is too short.
Power cut
Rinse hold has been selected
The programme is running or the dooris
locked for safety reasons
Power cut.
To release the door mechanically in the event of a power cut:
turn the programme selector to Off and unplug the mains plug from the-
■
socket
open the base panel and Drain out the water
■
pull the emergency release downwards and open the door at the same
■
time.
Before opening the door, make sure that there is no water or hot detergentsolu-
tion in the washer dryer.
Under no circumstances open the door with the emergency release while the-
drum is still turning.
Remedial Action
If necessary, clean the fabric sof-
tener compartment insert and fit it
correctly in compartment.
Turn on the tap.
Reduce the load size.
Select a suitable drying time.
The programme continues when
poweris restored. If you wish to
remove thelaundry during a power
cut, you must first Drain out the
water. Check whether:– the plug is
plugged into the socketcorrectly.–
the circuit breaker (fuse) hastripped;
if it has, call the after-salesservice
Select the programme p+0Empty
+Spin
and press the Start/Pause I but-
ton.
Wait until End appears on the dis-
play panel.
Unlock the door mechanically
Advertisement
Table of Contents
