The earthing system is properly
■
installed.
The mains cable is only replaced by
■
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
No multiple plugs/couplings or
■
extension cables are used.
If an earth-leakage circuit breaker is
■
used, only a type which displays this
symbol is used: z.
Only this symbol guarantees
compliance with the currently
applicable regulations.
The mains plug can be accessed at
■
all times.
The mains cable is not bent,
■
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The appliance was inspected
thoroughly before leaving the factory. To
remove any residual test water, run
Cottons 60°C programme the first time
without laundry.
Note:
The appliance must have been
■
installed and connected properly.
~ "Positioning and connecting"
on page 14
Never switch on a damaged
■
appliance.
Insert mains plug.
1.
Turn the water tap on.
2.
Close the door. Do not load any
3.
laundry.
Select theCottons 60°C programme.
4.
Open the detergent drawer.
5.
Positioning and connecting
Add standard detergent to
6.
dispenser II according
to manufacturer's instructions for
light soiling.
To prevent over sudsing, use
Note:
only half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
Close the detergent drawer.
7.
Select I (Start/Pause).
8.
When the programme ends, turn the
9.
dial to the Off position and open the
door.
Your appliance is now ready for use.
Transportation
e.g. when moving home
Preparatory work:
Turn off the water tap.
1.
Reduce the water pressure in the
2.
supply hose. ~ Page 44
Drain any residual water.
3.
~ Page 43
Disconnect the appliance from the
4.
mains.
Remove the hoses.
5.
Empty the dispensers.
6.
~ "Detergent drawer and housing"
on page 42
Installing the transport locks:
Remove the covers and keep them
1.
in a safe place.
Use a screwdriver if
Note:
necessary.
Insert all four sleeves.
2.
a) Clip the mains cable securely in
the holders.
b) Insert and tighten the screws.
c) Clip the hoses securely in the
holders.
Before switching on the appliance
again:
The transport bolts must be
Note:
removed.
en
23