Positioning and connecting
en
– Model: Aqua-Stop*
Connect also an external water
Tip:
filter (depending on the model)
between water supply hose and tap.
The filter filters dirt particles out of the
water.
Water filter must be cleaned regularly
to remove contaminants. This will
prevent blockages. See also ~
separate installation and cleaning
instruction for water filter.
Open the water tap carefully,
2.
checking the leak tightness of the
connection points. The screw
connection is under mains water
pressure.
Water outlet
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot water
(e.g. when draining hot water into a
washbasin).
Do not reach into the hot water.
Caution!
Damage to the appliance/fabrics
If the end of the drain hose is immersed
in the drained water, water may be
sucked back into the appliance and
may damage the appliance/fabrics.
Make sure that:
The end of the drain hose is not
■
immersed in the drained water.
22
The water drains away quickly
■
enough.
Do not kink the water drain hose
Note:
or put strain on it lengthways.
Connection
Drainage into a siphon
■
The connection point must be
secured using a hose clamp with a
diameter of 24 - 40 mm (inside
accessory).
Electrical connection
:
Warning
Risk of death!
There is a risk of electric shock if you
touch live components.
Never touch or hold the mains plug
■
with wet hands.
Only pull out the mains cable by the
■
plug and never by the cable, as this
could damage it.
Observe the following information and
ensure that:
Notes
The mains voltage and voltage
■
indicated on the appliance (rating
plate) are the same.
The connected load and fuse
required are specified on the rating
plate.
The appliance is only connected to
■
an alternating current via a properly
installed earthed socket.
The mains plug fits the socket.
■