Table of Contents
Advertisement
Setting Up Crestron Connected
To set up your projector for monitoring and control using a Crestron Connected system, make sure your
computer and projector are connected to the network.
Note: If you want to use the Crestron Connected system when the projector is turned off, you need to
adjust the Standby Mode setting in the Operation menu. The Standby Mode setting is displayed only if
the A/V Output setting in the Signal I/O menu is set to While Projecting, the Auto Power On setting in
the Network menu is set to Off, and the Power On Trigger setting in the Operation menu is set to Plug-in
Detection.
1. Press the Menu button.
2. Select the Network menu and press
3. Select Network Settings and press
4. Select the Projector Control menu and press
5. Set the Crestron Connected setting to On to allow the projector to be detected.
Note: Enabling Crestron Connected disables the Message Broadcasting feature in the Epson
Projector Management software.
6. When you are finished selecting settings, select Return and press
Settings menu.
7. Select Set, and follow the on-screen instructions to save your settings and exit the menus.
8. Turn off the projector, then turn it on again to enable the setting.
9. Start your Web browser on a computer or device connected to the network.
10. Go to the Epson Web Control screen by entering the projector's IP address into the browser's
address box.
11. Select the Crestron Connected settings. See the Crestron Web site for details.
Parent topic:
Related references
Input Signal Settings - Signal I/O Menu
Network Settings - Network Menu
Feature Settings - Operation Menu
Using Crestron Connected
Enter.
Enter.
Enter.
96
Enter to return to the Network
Advertisement
Table of Contents
