Table of Contents
Advertisement
4. Press the Menu button on the remote control, select the Pen/Touch menu, and press the
button.
5. Select the PC Interactivity setting and press the
6. Select one of the following as the Pen Tracking Mode depending on the operating system your
computer is using:
• Pen Mode: Windows or Mac
• Mouse Mode: Ubuntu
7. Press the
Enter button and press the Menu button to exit the projector's menus.
8. Hover near or tap on the board or the projected image with the interactive pen or your finger.
9. Make sure that PC Interactivity is enabled on the toolbar.
Note: You can use PC Interactive mode when connected over a network or with a USB cable
(connecting via USB is recommended). When connected via USB, enable the USB Display setting
in the projector's Signal I/O menu and connect the computer to the projector's USB-B1 port or the
USB-B port on the control pad (BrightLink 1485Fi+). When projecting using USB Display, response
time may be slower.
Enter button.
212
Enter
Advertisement
Table of Contents
