Storing Scan Limits In Ch 99; Programmable Vfo Function - Kenwood TS-870S Instruction Manual

9 MEMORY FEATURES
STORING SCAN LIMITS IN CH 99
+ This frequency can also be used for receiving
and transmitting after completion of this
procedure.
Select the End frequency limit using VFO B.
e =
= 2135800
|
Press [RX A].
Press [M.IN] to select the Memory Scrall mode.
ase auro
fy (815600
Mocr
Se ee
+ To exit from Memory Scroll mode and abort the
storage process, press [CLR].
5 Turn the M.CH/VFO.CH control to select channel! 99.
aac auto
99
a
Press [M.IN] to store the frequency limits.
+ Pressing [M.IN] overwrites new data on any
previous data in that channel.
Note: On some General market versions, the frequency limits must
be on the same band or they cannot be stored.
58
2 Turn the M.CH/VFO.CH control to select
channel 99.
a r3nann |
49 c LOU Lo
3 Press [DOWN] to check the Start frequency and
press [UP] to check the End frequency.
@ Programmable VFO Function
This function restricts the range of the Tuning
control to those frequencies included by the Start
and End frequencies that were programmed above.
One application of this function is to keep your
operating within the authorized frequency limits of
your license.
1 Press [RX M.CH] to select Memory Recall mode.
\
2 Turn the M.CH/VFO.CH control to select
channel 99.
sac auto
ee rynnann j
age egg
3 Turn the Tuning control and you will notice that
you can only tune from the Start frequency to the
End frequency. After reaching the End frequency,
the transceiver reverts back to the Start
frequency again.