Table of Contents
Advertisement
Hand Alignment
Adjustment
Strong magnetism or impact can cause the
time indicated by the analog hands to become
different from the time on the digital display. If
this happens, adjust hand alignment.
Adjusting Hand Alignment
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least five seconds.
Release the button when [H-S] stops
flashing and [SEC 00] starts to flash.
This enables adjustment of second hand
alignment.
Second hand
3.
If the second hand is not aligned with the
0 second position, use (B) and (D) to align
it.
Holding down (B) or (D) moves the hand
●
at high speed.
4.
Press (C).
This enables adjustment of the hour and
minute hands.
5.
If the hour and minute hands are not at 12
o'clock, use (B) and (D) to align them.
6.
Press (A) to complete the setting
operation.
Watch Operation Guide 5692
Other Settings
This section explains other watch settings you
can configure.
Enabling the Button
Operation Tone
Use the procedure below to enable or disable
the tone that sounds when you press a button.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
Release the button when the seconds
start to flash.
This enters the setting mode. The
●
hands automatically shift out of the way
for easy viewing of the screen.
3.
Press (C) eight times.
This causes [BEEP ON] or [BEEP OFF] to
flash on the display.
4.
Press (D) to select [BEEP ON] or [BEEP
OFF].
[BEEP ON]: Operation tone enabled.
[BEEP OFF]: Operation tone muted.
5.
Press (A) to complete the setting
operation.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Note that alarm and timer tones will still
●
sound even while the operation tone is
muted.
Seconds
16
Advertisement
Table of Contents
