Table of Contents
Advertisement
Monitoring function of wired remote controller
<RBC-AMTU
>
Content
Enter the service monitoring mode using the remote controller to check the sensor temperature or operation status of
the remote controller, indoor unit, and outdoor unit.
1
Push and hold the
mode.
The service monitor lights up. The CODE No.
2
TEMP.
Push the
button to change to CODE No. of the item to monitor. Refer to the next page
for CODE No.
3
Push the left part of the
monitor. Monitor the sensor temperature or operation status of the indoor unit and outdoor
unit in the refrigerant line.
4
Push the
button to return the display to normal.
<RBC-ASCU11- >
1
3
1
Push the [menu] button for over 10 seconds. "Monitoring function" is displayed on a screen.
2
Every pushing [
successively.
3
Push the [OFF timer] button to confirm the selected indoor unit.
4
Every pushing [
5
After you have finished checking, push the [ON/OFF] button, return to normal mode.
TEMP.
2
TIMER SET
TIME
FILTER
RESET
TEST
SET
4
, and
for 4 seconds or longer to enter the service monitoring
UNIT LOUVER
button (left side of the button) to change to the item to
Indoor unit
2, 4
5
or
] buttons, the indoor unit numbers in group control are displayed
or
] buttons, CODE No. of the item is changed successively.
ON / OFF
FAN
MODE
SAVE
VENT
CL
SWING/FIX
UNIT LOUVER
1
3
00 00 00 00 00
appears at first.
1,2
number
4
Data
- 60 -
"Monitoring function"
display
Advertisement
Chapters
Table of Contents
Troubleshooting
