Table of Contents
Advertisement
In the event of losing the Wi-Fi password or the password of the master unit, or in other cases, use the special Setup mode to restore
access to the unit functions.
To enter the special setup mode, press and hold the "Ventilation" button
beep sound and all LEDs start flashing.
The ventilator will stay in this mode for 3 minutes, after which it will automatically return to the previous settings.
To exit the setup mode immediately, press and hold the "Ventilatation" button
you hear a beep sound and all LEDs stop flashing.
The following settings are available in this mode:
Wi-Fi name:
•
Setup mode.
Wi-Fi password:
•
11111111.
The unit password is ignored.
•
AFTER CHANGING THE WI-FI PARAMETERS OF THE MASTER VENTILATOR, RECONNECT
Follow these steps to create a group of ventilators that are linked as master and slave ventilators:
•
Set the DIP switches on each ventilator to the position that corresponds to its role in the group (see "Position of the DIP switch").
•
Next, configure the Wi-Fi settings of the master ventilator by following the instructions in the Vents Home mobile app.
•
Set the master ventilator to the special mode as described above, and all LEDs on the ventilator casing will flash. ПRepeat the same
procedure with the slave ventilators and wait until the slave ventilators beep and the LEDs stop flashing. Switch the master unit back
to normal mode. To do this, press and hold the "Ventilation" button
Note:
If you have multiple Wi-Fi access points connected to your home router and you want to connect some of the ventilators to one
access point and some to another, then
•
Connect the master unit to the first Wi-Fi access point.
•
Complete the connection with the first group of the slave units.
•
Connect the master unit to the second Wi-Fi access point.
•
Complete connection with the second group of the slave units.
www.ventilation-system.com
SPECIAL SETUP MODE OF THE VENTILATOR
WHEN SETTING UP THE CONNECTION OF THE DEVICES, IT IS NECESSARY THAT
ALL SLAVE VENTILATORS ARE WITHIN THE WI-FI COVERAGE AREA OF THE MASTER
CONNECTING MASTER AND SLAVE VENTILATORS
on the ventilator casing for 5 seconds until you hear a
on the ventilator casing again for 5 seconds until
VENTILATOR.
THE VENTILATORS
until you hear a beep sound and the LEDs stop flashing.
21
Advertisement
Table of Contents
