Summary of Contents for NXP Semiconductors OM15008
Page 1
JN5169, remote control, lighting, SSL, LED, PCB antenna, ZigBee, NFC Abstract This user manual provides basic information about the OM15008 reference design. The OM15008 board contains a RF remote control for lighting applications. The board must be supplied with a low DC voltage of typical 2.5 V.
Variable transformer isolation symbols 2. Introduction The OM15008 smart lighting module is a highly versatile board that can be used in all kinds of applications but focuses on lighting applications. Because the board is so versatile, several components might left out in a specific application. The board is split up in two parts: ...
OM15037 adapter board and a standard USB cable. The Atomic programming dongle can be ordered from www.atomicprogramming.com. Contact your local NXP support office for the OM15037 adapter board. A flex foil is used to connect the OM15008 board to the OM15037 board. Suitable flex foils can be found in Table 2.
OM15008 smart lighting module 6. Schematic The OM15008 board can also be fitted with a JN5169 which has 512 kB embedded flash, lower standby power and 10 dBm transmit power. The antenna matching circuit and crystal oscillator component value's must be changed when the JN5169 is mounted.
8. Board layout Fig 5. Top and bottom OM15008 layout Note: the top side of the OM15008 board is facing towards the top side of the Large Signal Board (LSB). UM10911 All information provided in this document is subject to legal disclaimers.
OM15008 smart lighting module 9. Board dimensions Fig 6. Board dimensions 10. Functional description 10.1 Pinout The OM15008 board has a programming connector and two headers: Table 4. Pin list for the programming connector Pin name JN5169 pin Function Electrical J3.1...
Page 10
Header J2 has 4 digital outputs to the LSB that can be used to control the LED driver on the LSB. The function of these pins depends on the LSB on which the OM15008 board is mounted and the software that is used.
NXP website. 10.2.5 Anti-flicker current bleed The anti-flicker current bleeder is used when the OM15008 is used in a low cost solution where the LED driver is also used for supplying the OM15008 board. This only works in combination with the appropriate software.
The English version shall prevail in case of any discrepancy between the translated and English versions. In no event shall NXP Semiconductors be liable for any indirect, incidental, punitive, special or consequential damages (including - without limitation - Evaluation products —...
Need help?
Do you have a question about the OM15008 and is the answer not in the manual?
Questions and answers