Canon PC300 Service Manual page 99

Moving a metal object from a cold to warm place can cause droplets of water to appear on
its surface.
The phenomenon is known as condensation, and condensation in the copier can
trigger such problems as blank copies. If any such problem is expected, leave the copier alone
at the site of installation at least one hour before unpacking it.
Work Description
Open the shipping carton.
Take out the accessories. | Make sure that the Operator's Manual is in the box.
Remove the cover bag from the copier, | » Check the covers for damage and deformation caused
and detach all strips of tape that hold during transit.
parts. * Slide out the manual feed tray.
* Slide out the delivery tray.
4 |Move the copyboard to the left until it
stops, and press the open/close button
to open the copier's top cover.
5 |Pull the two cardboard pieces, if found
inside the copier at either end of the
charging roller, straight up and out of
the copier.
Note: Do not touch the transfer
charging roller inside the copier.
Take. out the cartridge from the bag.
(If the cartridge is installed in the
copier, pull it out to the front.)
Cardboard <\ Ze
Transfer charging roller
§-2 COPYRIGHT © 1994 CANON INC. CANON PC300/320/225, FC210/290 REV.0 JULY 1994 PRINTED IN JAPAN {IMPRIME AU JAPON)