Canon PC300 Service Manual page 82

'MECHANICAL SYSTE!
i. Copyboard Assembly
Oetaching the Copyboard Cover
2. Beiaching the Copyboard
1) Move the copyboard © to the left until it
stops, and remove the screws (Q@,
4.
1) Lift the right rear corner of the copy- M3xé6, white; @, M4xX10, black).
board cover about 5 mm; then, slide it to
the front.
Figure 4-112
2) Slide the left rear corner the same way.
Figure 4-113
4-4 COPYRIGHT © 1904.CANON INC.
Figure 4-114
2) 'Move the copyboard to the right by
hand, and remove the screw (M4X10;
ae @; then, detach the copyboard
Figure 4-115
Note:
1. Do not disassemble the rail.
2... To attach the copyboard, fit the copy-
board glass into the. rail:at the front,
and screw the rear rail portion in
place.
CANON PC300320/825, FC210/290 REV.O JULY 1994 PRINTED IN JAPAN (IMPRIME AU JAPON}