Canon PC300 Service Manual page 15

« GENERAL DESCRIPTIO
Copying on OHP Film Manual Feeding
* Set one sheet of film on the pick-up
tray for each copy. mH PC300/FC210
¢ Depending on the environment of the 1) Set a document on the copyboard.
site, a press on the Copy Start key 2) Adjust the Density Control! lever to suit
may not pull the film inside the copier; the. document.
if this is the case, perform the follow- 3) Slide the pick-up guide to suit the size of
ing: copy paper.
4) Insert copy paper along the pick-up
1) Place copy paper under the film; stagger guide.
the sheet and film so that the leading * The copier starts copying operation
edge of the film is about 1 cm behind automatically as soon as it detects
that of the paper. paper.
« To continue copying, insert the next
paper when the copyboard starts to
OHP
tom
i return.
Making Two-Sided Copies
1) Turn over the copy while maintaining its
feeding direction.
a * Make sure that the paper is not moist
Copy paper or curled.
« Use paper of 60 to 128 g/m? when
making two-sided copies.
* Do not process each side more than
twice.
Figure 1-7
2) Hold the trailing edge of the copy paper,
and set the sheet and film on the pick-up
tray.
3) While holding the trailing edge of the
copy paper, press the Copy Start key.
Remove the paper when the film begins
to move into the copier; the paper will no
longer serve its purpose.
Figure 1-9
Making Overlay Copies
You can make two- or three-colored
copies by replacing the cartridge.
« Use paper of 60 to 128 g/m? when
making overlay copies.
* Do not process each side more than
three times.
Figure 1-8
Note:
Take away each OHP film delivered to
the copy tray.
COPYRIGHT © 1994 CANON INC. CANON PC3001320/925, FC210/230 REV.0 JULY 1994 PRINTED IN JAPAN (IMPRIME AU JAPON) 1-9