Canon PC300 Service Manual page 17

ENERAL DESCRIPTIO
2) Set the cartridge back in the copier, and 5) Hold the cartridge with its Warning label
make a copy. facing the left, and insert it in the copier
a. If the output returns to normal, with care until it butts against the rear.
* The cartridge may be used further;
advise the user, however, to obtain a
Spare cartridge.
b. If the output fails to return to normal,
° Replace the cartridge as described
below.
2. Replacing the Cartridge
1) Move the copyboard to the left until it
stops; then, press the open/close button
to open the top cover.
2) Slide the cartridge out of the copier.
3) Hold the cartridge with the Warning label
facing up, and rotate it about 90 degrees Figure 1-14
efit in both directions.
| 6) Close the top cover, and return the copy-
"~ board to the center.
Note:
You can replace the black toner cartridge
with any color cartridge the same way.
Figure 1-12
-) 4) Detach the tip of the seal attached to the
4 cartridge, and pull it straight out to the
front; about 50 cm.
Figure 1-13
COPYRIGHT © 1904 CANON INC. CANON PC300/3200%25, FC210/290.REV.0 JULY 1904 'PRINTED IN JAPAN (IMPRIME AU JAPON) 1-11