Advertisement
PANEL FACILITIES
@ ENHANCER switch/indicator
When performing VCR recording, the built-in enhancer allows
you to compensate the recorded picture quality. Please the
switch so that the indicator lights, then adjust the image quali-
ty using the video compensation controls.
@ Video compensation controls
Use
these
compensation
controls
after
pressing
the
ENHANCER switch so that the indicator lights.
{SHARPNESS]:
Use to sharpen hazy image contours.
{DETAIL}:
Use to compensate for flat image detail.
{NOISE CANCEL]:
Use to reduce noticeable video noise.
The video image compensated with these controls can be viewed
on a TV monitor connected to the rear panel REC MONITOR or
MONITOR OUT terminals.
NOTE:
© When using the video compensation controls, perform compen-
sation based on the quality of the playback image. If too much
compensation is applied, black and white stripes may appear in
contour areas. As a result, the image should be adjusted to the
optimum
quality
whife
viewing
the results
on a color TV
monitor connected.
To view the enhanced image on the color monitor connected to
the MONITOR OUT terminal, select the playback source with
the recording selector switch, and use the video input selector
switch to select the component being used for video recording.
@® VCR2 front panel terminals
Use to connect a second video cassette recorder.
{INPUT]
VIDEO:
For video input (connect to VCR's video output ter-
minal).
AUDIO:
For audio input (connect to VCR's audio output ter-
minals).
22
<ARB1140>
[OUTPUT]
VIDEO:
For video output {connect to VCR's video input ter-
minals).
AUDIO:
For audio
output
(connect
to VCR's
input ter-
minals).
(® Tone controls
These controls can be used only when the TONE indicator is
fit.
{BASS]———_
Use to adjust low frequency sounds.
The central [0] indicates the standard
(flat)
position. When
the control is rotated to the
right, low-frequency
sounds
are augmented;
when
rotated
to
the
left,
low-frequency
sounds are attenuated.
[TREBLE] ——
Use to adjust high-frequency sounds.
The central {0} indicates the standard (flat)
position, When
the control is rotated to the
right, high-frequency sounds are augmented;
when
rotated
to
the
left,
high-frequency
sounds are attenuated.
@ BALANCE control
Normaily
leave in the center
position.
Use to adjust the
balance of sound from right and left channets.
@ TONE switch/indicator
[ON]
——--~
The
TONE
indicator
lights,
and
audio
inputs
from all components are played back after pass-
ing through the tone contro! circuits. In this con-
dition, the tone controls (BASS, TREBLE)
can
be used to adjust sound quality.
{QFF]——-
The TONE
indicator goes out, and signals are
played back without passing through the tone
control circuits.
Advertisement
