Advertisement
USE OF LEARNING FUNCTIONS
{Operation Example]
Using the remote
control
unit of your
VCR
to program
the
playback command.
* itis recommended that the name of the key and its function cor-
respond. This is convenient when operating equipment.
2
Learn @
@ TRANSMIT
USE, LEARN
@--
el
TAPE/VCA
DAT.
o7]
e
Co
I
a)
VCR
=VCR
CH+
POWER
=
<3
a]
Ce
~~
v
AuDISY eaux
(@ LEARN indicator
This indicator shows the remote control unit operating condi-
tion.
tir:
Learning is possible.
OFF:
Regular remote contro! functions are performed.
FLASHING:
Means the key is not available for programming a new com-
mand in the current mode.
@ TRANSMIT indicator
This indicator flashes when remote control signals are sent.
@ LEARN selector switch
Set as follows:
LEARN:
This position is used for storing the codes of your remote con-
tro} unit.
USE:
Set to this position after codes have been stored in the LEARN
position. Set to this position for normal operation.
{Operation example]
1. Set the LEARN selector switch of the programmable remote
contro! unit to the LEARN
position and set the TRANSMIT
mode selector switch to the VIDEO position.
* Programming is possible with the TRANSMIT mode selector
switch in any position, but VIDEO is used as an example.
18
<ARB1140>
. Place the transmission sections of the programmable remote
contro! unit and the remote contro! of the VCR facing each
other.
1 to 2 inches
* Place the two units on a table, separated by 2 to 5 cm (1 to
2 inches).
Memorization wili not be possible if they are too close.
. Hold down the VCR PLAY key of the programmable remote
control unit until the LEARN indicator fights up, then release
the key.
4. Hold down the PLAY key of the VCR remote control unit.
. Release the key of the VCR remote control unit after making
sure that the LEARN
indicator has gone out on the Pioneer
remote control unit.
NOTE:
If the LEARN indicator flashes, it indicates that you are trying
to preset a key not available for the learning function, or other-
wise the program capacity has been exceeded.
In case the
program capacity has been exceeded, the function programm-
ed last will not be memorized correctly. All previously pro-
grammed functions, however, will be retained in memory and
may be used as they are if the last function is not essentila.
For re-programming refer to page 19 "Returning to the Initial
Settings".
. Set the LEARN
selector switch of the programmable remote
control unit to the USE position.
* The previous code (Pioneer uniform remote control code or
code for other equipment)
is erased and replaced by the
new code.
. Check that the program works.
* Try actual operation and make sure the unit works properly.
* If the VCR does not operate when pressing the key, change
angle, position and distance between
both remote control
units and repeat the programming procedure.
* When
programming,
make sure that the function indica-
tions (for example, D>, DP, HB) on the other remote control
unit and the
programmable
remote
control
unit are the
same. This will facilitate operation.
Advertisement
