• See "Setting the EDACS ID Format (EDACS Systems
Only)" on Page 69
• See "Reviewing Locked Out Frequencies" on
Page 89
• See "Setting Channel Attenuation (Conventional
Channels Only)" on Page 77
• See "Deleting Systems" on Page 71
• See "Copying Systems" on Page 71
• See "Setting System Frequencies" on Page 59
• See "Entering/Editing EDACS Channel Groups"
on Page 59
Setting System Frequencies
SET FREQUENCIES
NEW FREQUENCY
Input a system frequency, then press E. The scanner then
prompts you to enter the LCN for the entered frequency.
Enter the LCN, then press E.
To enter additional frequencies, press
Frequency, then repeat the above.
Note: The scanner only accepts a single frequency and
no LCN for SCAT systems.
Entering/Editing EDACS Channel Groups
To enter channels in a system, first set up a channel
group (or groups) to hold the channels. Then, enter the
channel and channel parameters in the group(s).
Setting Up a Channel Group
EDIT GROUP
NEW GROUP
The scanner creates a group with a default name of
GROUP nn. nn increments by one for each new group you
create within a system.
Next, refer to the appropriate section to set group-wide
options:
E
E
E
E
Programming Radio Systems
59
, scroll to New
Menu