Special Precautions / Important Information - Modine Manufacturing AMP Installation And Service Manual

SPECIAL PRECAUTIONS / IMPORTANT INSTRUCTIONS
SPECIAL PRECAUTIONS / IMPORTANT
INSTRUCTIONS
THE INSTALLATION AND MAINTENANCE INSTRUCTIONS
IN THIS MANUAL MUST BE FOLLOWED TO PROVIDE SAFE,
EFFICIENT AND TROUBLE-FREE OPERATION. IN ADDITION,
PARTICULAR CARE MUST BE EXERCISED REGARDING
THE SPECIAL PRECAUTIONS LISTED BELOW. FAILURE
TO PROPERLY ADDRESS THESE CRITICAL AREAS COULD
RESULT IN PROPERTY DAMAGE OR LOSS, PERSONAL
INJURY, OR DEATH. THESE INSTRUCTIONS ARE SUBJECT
TO ANY MORE RESTRICTIVE LOCAL OR NATIONAL CODES.
HAZARD INTENSITY LEVELS
1. DANGER: Indicates an imminently hazardous situation
which, if not avoided, WILL result in death or serious injury.
2. WARNING: Indicates a potentially hazardous situation which,
if not avoided, COULD result in death or serious injury.
3. CAUTION: Indicates a potentially hazardous situation which,
if not avoided, MAY result in minor or moderate injury.
4. IMPORTANT: Indicates a situation which, if not avoided,
MAY result in a potential safety concern.
DANGER
Appliances must not be installed where they may be exposed
to a potentially explosive or flammable atmosphere.
WARNING
1. Disconnect power supply before making wiring connections
to prevent electrical shock and equipment damage.
2. All appliances must be wired strictly in accordance with
wiring diagram furnished with the appliance. Any wiring
different from the wiring diagram could result in a hazard
to persons and property.
3. Ensure that the supply voltage to the appliance, as
indicated on the serial plate, is not 5% greater than rated
voltage.
4. When servicing or repairing this equipment, use only
factory-approved service replacement parts. A complete
replacement parts list may be obtained by contacting
Modine Manufacturing Company. Refer to the rating
plate on the appliance for complete appliance model
number, serial number, and company address. Any
substitution of parts or controls not approved by the
factory will be at the owner's risk.
5. Do not operate any heater if it malfunctions. Disconnect
power at service panel and have heater inspected by a
qualified installation and service agency.
6. Do not insert or allow foreign objects to enter any intake
or exhaust opening.
7. Use this heater only as described in this manual.
8. Components of the heater are hot when in use. To avoid
burn, do not let bare skin touch hot surfaces.
9. Extreme caution is necessary when any heater is used
by or near chidren or invalids and whenever the heater is
left operating and unattended.
10.The heater must be installed properly before use.
2
CAUTION
1. All literature shipped with this unit should be kept for
future use for servicing or service diagnostics. Do not
discard any literature shipped with this unit.
2. Be sure no obstructions block air intake or discharge of
the appliance.
3. Do not install applicane in outdoor, wet or moist
locations.
4. Do not install appliance outdoors.
5. Clearances to combustible materials are critical. Be
sure to follow all listed requirements. See Table 3.1.
6. The bottom of the appliance must be at least - 6ft from
the finished floor in the USA and 8ft in Canada.
7. Do not attach duct work, air filters, or polytubes to any
appliance.
8. Ensure that the supply voltage to the appliance, as
indicated on the serial plate, is not 5% less than the rated
voltage.
9. Do not reuse any electrical component which has been
wet. Such component must be replaced.
10. When servicing or repairing this equipment, use only
factory approved service replacement parts. A complete
replacement parts list may be obtained by contacting
Modine Manufacturing Company. Parts not approved by
the factory will be at the owner's risk.
11. Do not operate any heater if it malfunctions. Disconnect
power at service panel and have heater inspected by a
qualified installation and service agency.
12. Do not reuse any electrical component which has been
wet. Such component must be replaced.
SAVE THESE INSTRUCTIONS.
13.
IMPORTANT
1. To check most of the Possible Remedies in the trouble-
shooting guide listed in Table 8.1, refer to the applicable
sections of the manual.
2. Start-up and adjustment procedures must be performed by
a qualified service agent.
2-529.0