Warning And Information Signs; Safety Instructions For The Electrical Power Supply; Personal Protective Equipment - Abicor Binzel iROB 501 PRO Original Operating Instructions

2 Safety

2.3 Warning and information signs

The following warning, notice and mandatory signs can be found on the product:
These markings must always be legible. They may not be covered, obscured, painted over, or removed.

2.4 Safety instructions for the electrical power supply

► Ensure that the power supply cable is not damaged, for example, by being driven over, crushed or torn.
► Check the power supply cable for damage and wear at regular intervals.
► If it is necessary to replace the power supply cable, use only ABICOR BINZEL spare parts.
► Only a qualified electrician should replace the power supply cable and the mains plug.
► Splash-water protection and mechanical stability must be ensured when replacing the mains plug of
the power supply cable.

2.5 Personal protective equipment

► Wear your personal protective equipment (PPE).
► Ensure that others in close proximity are also wearing personal protective equipment.
Personal protective equipment consists of protective clothing, eye protection, protective gloves, and safety
shoes.
EN - 8
► Read and observe the operating instructions.
► Wear eye protection.
Warning against hot surfaces. Risk of burns.
► Do not touch hot surfaces.
► Wear protective gloves.
Electrical voltage caution. Danger of electric shock.
► Only a trained electrician should open the device.
► Interrupt the electrical power supply before opening the device.
Electrical voltage caution. Danger of electric shock.
► Do not touch live parts such as the welding wire and drive unit or any metal parts that
touch the welding wire.
Caution: moving parts.
► Keep away from moving parts.
► Keep hands, loose clothing and tools away during operation.
Property damage due to improper use.
► Do not expose the device to strong vibrations or impact in the marked areas.
Damage to material due to electrostatic discharge on contact.
► Have the device grounded by a qualified electrician before startup.
Material damage due to electrical voltages.
► Do not expose the device to high electrical voltages in the marked areas.
®
iROB 501 PRO