Supermicro AS-1114CS-TNR User Manual page 84

A+ Server AS -1114CS-TNR/AS -1114CS-TNR-EU User's Manual
UTF8 encoding to map Unicode characters into one or more bytes. The options are VT100,
VT100+, VT-UTF8, and ANSI.
Bits per Second
This item sets the transmission speed for a serial port used in Console Redirection. Make
sure that the same speed is used in the host computer and the client computer. A lower
transmission speed may be required for long and busy lines. The options are 9600, 19200,
57600, and 115200 (bits per second).
Flow Control
Use this item to set the flow control for Console Redirection to prevent data loss caused
by buffer overflow. Send a "Stop" signal to stop sending data when the receiving buffer
is full. Send a "Start" signal to start sending data when the receiving buffer is empty. The
options are None, Hardware RTS/CTS, and Software Xon/Xoff.
Data Bits EMS
Parity EMS
Stop Bits EMS
CPU Configuration
SMT Mode
Use this setting to specify Simultaneous Multithreading. Options include Off for 1T single
thread and Auto for 2T two-thread if your system is capable of it.
Core Performance Boost
This setting is used to configure for Core Performance Boost. Options include Auto and
Disabled.
Global C-state Control
This setting is used to configure for Global C-state Control. Options include Disabled, Enabled,
and Auto.
Local APIC Mode
Options include Compatibility, xAPIC, x2APIC, and Auto.
CCD Control
Sets the number of CCDs to be used. Once this option has been used to remove any CCDs,
a POWER CYCLE is required in order for future selections to take effect. Options inlcude
Auto, 2 CCDs, 3 CCDs, 4 CCDs, and 6 CCDs.
84