Supermicro AS-1114CS-TNR User Manual page 39

Installing an Expansion Card
1. Power down the system as described in section 3.1 and remove the top cover.
2. Remove the bracket and sections at the rear of the chassis.
3. Insert the expansion card into a slot on the riser card while aligning the expansion card
back plate with the open slot in the rear of the chassis.
Figure 3-4. Riser Card Bracket and Expansion Slots
4. Insert the riser card into the motherboard expansion slot while aligning the riser card
bracket with the rear of the chassis.
Chapter 3: Maintenance and Component Installation
39
Brackets
Expansion Cards