Table of Contents
Advertisement
WARNING!
•
Do not let anyone sit in the vehicle when it is
on a jack.
•
Do not get under the vehicle when it is on a
jack. If you need to get under a raised vehicle,
take it to a service center where it can be
raised on a lift.
•
Only use the jack in the positions indicated
and for lifting this vehicle during a tire
change.
•
If working on or near a roadway, be extremely
careful of motor traffic.
•
To assure that spare tires, flat or inflated, are
securely stowed, spares must be stowed with
the valve stem facing the ground.
Jack Warning Label
1. Remove the spare tire, jack and tools from the
stored location.
2. Loosen (but do not remove) the wheel lug
nuts by turning them to the left one turn while
the wheel is still on the ground.
3. Assemble the jack and jacking tools. Connect
the jack handle driver to the extension, then to
the lug wrench.
Assembled Jack And Tools
NOTE:
If your vehicle comes with factory equipped
35 inch (88.9 cm) tires, a jack lift block is pro-
vided in the rear cargo area. The jack lift
block is used to provide higher ground clear-
ance when changing a flat or spare tire. When
placing the jack lift block under the jack, be
sure the bottom of the jack fits securely
inside of the raised edges of the block.
Jack Lift Box Usage
4. Operate the jack from the front or the rear of
the vehicle. Place the jack under the axle tube,
as shown. Do not raise the vehicle until you
are sure the jack is fully engaged.
Front Lifting Point
NOTE:
Keep the jack and tools aligned while raising
the vehicle to prevent tool damage.
EMERGENCY
59
Advertisement
Table of Contents
