Chapter 3 Fuel Injection Equipment
_2_.
_G_o_ve_r_n_o_r _____________________________
3,4]H3(B)(CJE
3. Don't forget to mount the washers to both sides
of the governor lever.
(8) After you have mounted the O-ring, tape the governor
lever in the opposite direction, and mount the E-shaped
stop rings on !he grooves at both ends.
NOTE: After mounting the governor lever assembly, make
sure the governor lever assembly moves smoothly.
3-12
(9) Fit the stop lever return spring to the end of the gover-
nor lever shaft.
(10) Hook the governor spring on the control lever shaft and
tension lever hook with radio pliers.
(11) Pull the governor link as far as possible towards the
governor case mounting surface, insert the governor
link pin in the fuel control rack pin hole and fit the
snap pin on it.
Printed in Japan
HINSHI-H8009