Yanmar 3JH3E Service Manual page 53

Chapter 3 Fuel Injection Equipment
=2~.~G~o~ve~.r~n~o~r-----------------------------~4JH3(BXC)E
(11) Remove the governor link from the governor lever.
3-8
NOTE: The governor assembly consists of the governor
fever, tension bar, bushing, throttle spring and
shifter, and
is
normally not disassembled.
The spring pin is removed when you replace
the shifter or throttle spring.
(12) When you need to pull out the stop lever, remove the
stop lever shaft stop pin, and lightly tap the inside of
the governor case.
(131 When you need to pull out the control fever shaft, tap
the end of the shaft with a wood hammer.
NOTE : 1.
Do
not remove the fuel limit nut from the governor
case unless necessary.
Printed in Japan
HINSHI-H8009