US Robotics SportsterVoice User Manual page 49

S-Registers
To change a setting, use the ATSr=n command, where r is the register and n is a decimal value from 0*255 (unless
otherwise indicated).
Register Default
S0 1
Mode. When set
S1 0
(read only).
S2 43
Default character
S3 13
S4 10
S5 8
<BS>.
S6 2
dialing.
S7 60
answers before
code.
S8 2
command.
S9 6
modem's carrier signal
46
Function
Sets the number of rings on which to
to 0, Auto Answer is disabled.
Counts and stores the number of rings
Stores the ASCII decimal code for the
is "+."
Stores the ASCII code for the Carriage
Stores the ASCII decimal code for the Line
Stores the ASCII decimal code for the
Sets the number of seconds the modem
Sets the number of seconds the modem
returning on-hook and sending a No Carrier
Sets the duration, in seconds, for the pause
Sets the required duration, in tenths of a
before recognition by your modem.
answer in Auto Answer
from an incoming call
escape code character.
Return character <CR>.
Feed character <LF>.
Backspace character
waits for dial tone before
waits for a carrier or
result
(,) option in the Dial
second, of the remote