Table of Contents
Advertisement
Windows 2000:
Click Windows Start, Settings, and then Control Panel.
Double-click the Phone and Modem Options icon and then click the
Modems tab. You will see a list of installed modems.
Windows NT 4.0, Me, 98, and 95:
Click Windows Start, Settings, and
Control Panel. Double-click the Modems icon. You will see a list of installed
modems.
You can also add, remove, or view the properties of modems from this
window. The U.S. Robotics modem you have installed should be present in
the list of installed modems. If none of the modem descriptions in the list
matches your U.S. Robotics modem or if no modems are listed, your modem
is not installed properly. Try reinstalling your modem.
Possible solution:
If you are using Dial-up Networking, it may not be configured correctly.
Check your configuration and make sure that the correct port is selected.
Windows XP and 2000:
Click Windows Start, Control Panel (or Settings in
Windows 2000), and Network and Dial-up Connections. Right-click the
connection you are trying to use, and then click Properties. Make sure that
the description in the "Connect Using" box (under the General tab) matches
the description of the modem you are using. If it does not match, select the
proper modem description.
Windows Me, 98, and 95:
Double-click the My Computer icon on your
desktop, and then double-click Dial-up Networking. Right-click the
connection you are trying to use and click Properties. Make sure that the
description in the modem box matches the description of the modem you
are using. If it does not match, select the proper modem description.
Windows NT 4.0:
Click Windows Start, Settings, and Control Panel. Double-
click the Dial-up Monitor. Your modem should be in the Device window.
Possible solution:
Your communications software may not function properly if you have more
than one version of the software installed, you are using an older version,
or you have more than one communications application installed on your
system. We highly recommend using the communications software
provided with your modem on the Installation CD-ROM.
My modem is responding but is reporting a No Dial Tone message.
Possible solution:
Your phone cord may not be plugged into the modem's connector. Also
make sure that the other end of the phone cord is plugged into a working
telephone wall jack.
12
Advertisement
Table of Contents
