Measuring - Parkside PLDM A1 Operation And Safety Notes

˜ Measuring
1 . Hold the product and make sure that it is as least 20 cm
away from the object to be tested and other objects .
2 . Press the TEST button
The display
momentarily . Then the display shows the AUTO symbol
and the measurement unit mm, and meanwhile, "–",
"––", and "–––" appear on the display sequentially and
repeatedly .
3 . Press the UNIT button
measurement unit: mm or mil .
4 . After switching on the product, the product switches by
default to AUTO test mode . The display shows AUTO
as an indication . Repeatedly hold down the UNIT button
for about 1 sec to step through NFe test mode
(NFe appears as an indication), Fe test mode (Fe appears
as an indication), and back to the AUTO test mode
(AUTO appears as an indication) .
5 . If the product is not calibrated, select AUTO test mode .
NOTES:
The advantage of using AUTO test mode is that it is not
o
necessary to calibrate the product .
20 GB
to switch on the product .
3 ] [
shows all segments and symbols
2 ] [
4 ] [
to select the desired