Measuring Lengths; Changing Measurement Mode; Continuous Measurement Mode; Single Measurement Mode - Parkside PLEM 20 A4 Operation And Safety Notes

Measuring lengths

Briefly press the MEAS button
beam. Once the laser is switched on, this is indicated on
the top left corner of the display
Note: If laser beam is already activated, the above men-
tioned step can be skipped.
Now aim the laser at the target point. Briefly press the
MEAS button
the measured value will be shown on the bottom line of the
display
3
If needed to measure another distance, repeat above steps.
Newly measured value will be shown on the bottom line of
the display
shown in the middle of the display
beam will be turned off.

Changing measurement mode

Continuous measurement mode

Under single measurement mode, press and hold the
MEAS button
urement mode.
Laser icon flashes in continuous measurement mode

Single measurement mode

Under continuous measurement mode, press and hold the
MEAS button
mode.
Laser icon stays on in single measurement mode.
14 GB/IE/NI
again. If the measurement is successful
4
and the laser beam will be turned off.
and the previous measured value will be
3
for 3 seconds to enter continuous meas-
4
for 3 seconds to enter single measurement
4
again to activate the laser
4
by the icon
3
. Now, the laser
3
.
7