Parkside PLDM A1 Operation And Safety Notes page 21

The disadvantage of using AUTO test mode is that
o
measurement accuracy in AUTO test mode is relatively
low .
6 . If you have calibrated the product in the NFe or Fe test
mode using the naked substrate
product in the same test mode (in which the product has
been calibrated by using the naked substrate of this object) .
NOTES:
The advantage of using NFe or Fe test mode is that
o
measurement accuracy in NFe or Fe test mode is high .
The disadvantage of using NFe or Fe test is that the
o
product must be calibrated in this selected test mode
beforehand by using the naked substrate of this object .
7 . Firmly press the probe
surface of the object to be tested . When the product
detects a stable reading, this reading is shown on the
display . The reading is the value of the total thickness of the
non-magnetic coatings on the substrate of this object . This
reading is held on the display until the product switches off
or until a new measurement is made . If necessary, press the
TEST button to erase the reading and then test again .
of this object, set the
8 ] [
perpendicularly against the
1 ] [
GB 21