Steps
1. Align the USB Type-C board with the screw holes on the system-board assembly.
2. Align the USB Type-C shield on the left side with the screw holes on the system-board assembly.
3. Replace the three screws (M2x4) that secure the USB Type-C board to the system-board assembly.
4. Connect the USB Type-C board cable connector to the USB Type-C board and close the latch to secure the cable.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Follow the procedure in
After working inside your
computer.
Touchpad
Removing the touchpad
CAUTION: The information in this removal section is intended for authorized service technicians only.
61