Power button
Removing the power button
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
memory
module.
4. Remove the
M.2 2280 solid state drive
5. Remove the
M.2 2230 solid-state drive
6. Remove the
wireless
card.
7. Remove the
top
heat-sink.
8. Remove the
rear I/O
cover.
9. Follow the procedure from step 1 to step 20 in
NOTE: The system board can be removed and installed along with the audio board and heat sink-assembly. This simplifies the
removal and installation procedure and avoids breaking the thermal bond between the system board and heat sink.
About this task
The following images indicate the location of the power button and provide a visual representation of the removal procedure.
Before working inside your
or
M.2 2230 solid-state drive
in slot three and four, if applicable.
Removing the system
computer.
in slot one and two, whichever is applicable.
board.
85