Table of Contents
Advertisement
18. Adhere the power-adapter port cable to the system board.
19. Connect the power-adapter port cable to the connector (DCIN1) on the system board.
20.Connect the display cable to the connector (LCD1) system board and close the latch to secure the cable.
21. Adhere the tape that secures the display-cable connector latch to the system board.
22.Connect the camera cable to connector (CAM1) the system board.
23.Adhere the tape securing the camera cable to the system board to secure the cable.
24.Connect the rear I/O board cable to the system board.
25.Adhere the tapes securing the rear I/O board cable to the system board.
Next steps
1. Install the battery.
2. Install the
rear I/O
cover.
3. Install the
top
heat-sink.
4. Install the
small
fan.
5. Install the
wireless
card.
6. Install the
M.2 2230 solid-state drive
7. Install the
M.2 2280 solid-state drive
8. Install the
memory
module.
9. Install the
base
cover.
10. Follow the procedure in
in slot three and four, if applicable.
or
M.2 2230 solid-state drive
After working inside your
in slot one and two, whichever is applicable.
computer.
81
Advertisement
Table of Contents
