SERVICE MANUAL MICRO COMPONENT SYSTEM MB297 2004 UX-H300,UX-H330,UX-H350 UX-H300 Area suffix US ------------------------ Singapore UT ---------------------------- Taiwan UW ----------- Brazil,Mexico,Peru UX-H330 Area suffix UT ---------------------------- Taiwan UW ----------- Brazil,Mexico,Peru UX-H350 Area suffix UJ ---------------------- U.S.Military TABLE OF CONTENTS PRECAUTION............... . . 1-3 SPECIFIC SERVICE INSTRUCTIONS .
Page 2
SPECIFICATION 15 W per channel, min. RMS, driven into 4 Ω at 1 kHz with no more Amplifier Section Output Power than 10% total harmonic distortion. (IEC268-3) Audio input sensitivity/Impedance (at 1 kHz) AUX:500 mV/50 kΩ 4 Ω - 16 Ω Speakers/Impedance Tuner FM tuning range...
SECTION 1 PRECAUTION Safety Precautions (1) This design of this product contains special hardware and voltmeter. many circuits and components specially for safety purpos- Move the resistor connection to each exposed metal es. For continued protection, no changes should be made part, particularly any exposed metal part having a return to the original design unless authorized in writing by the path to the chassis, and measure the AC voltage across...
Page 4
Preventing static electricity Electrostatic discharge (ESD), which occurs when static electricity stored in the body, fabric, etc. is discharged, can destroy the laser diode in the traverse unit (optical pickup). Take care to prevent this when performing repairs. 1.5.1 Grounding to prevent damage by static electricity Static electricity in the work area can destroy the optical pickup (laser diode) in devices such as laser products.
Important for laser products 5.CAUTION : If safety switches malfunction, the laser is able 1.CLASS 1 LASER PRODUCT to function. 2.DANGER : Invisible laser radiation when open and inter 6.CAUTION : Use of controls, adjustments or performance of lock failed or defeated. Avoid direct exposure to beam. procedures other than those specified here in may result in 3.CAUTION : There are no serviceable parts inside the hazardous radiation exposure.
SECTION 3 DISASSEMBLY Main body 3.1.1 Removing the front panel assembly (See Fig.1 to 6) (1) From the back of the body, remove the two screws A, and the two screws B attaching the front panel assembly. CD mechanism assembly (2) Remove the six screws D on both sides of the body.
Page 8
Front panel assembly CD mechanism assembly Front panel assembly FM-ANT Rear panel assembly Fig.4 CD mechanism assembly Joint a Main board CN402 CN801 Rear cover assembly Fig.6 Front panel assembly Rear cover assembly Fig.5 1-8 (No.MB297)
Page 9
3.1.2 Removing the main board (See Fig.7, 8) • Prior to performing the following procedure, remove the front panel assembly. Front panel assembly CD mechanism assembly (1) Disconnect the wire from all connectors on the main board. (2) Disconnect the wire from the two connectors on the cas- CN103 sette mechanism assembly.
Page 10
3.1.3 Removing the CD mechanism assembly (See Fig.9, 10) • Prior to performing the following procedure, remove the front panel assembly and the main board. CD door switch (1) Release the four bands setting the wire. Front panel assembly CD mechanism assembly (2) Disconnect the wire from the connector on the CD door switch and from CN601, CN603...
Page 11
3.1.4 Removing the CD mechanism assembly (See Fig.11 to 13) • Prior to performing the following procedure, remove the front panel assembly, the main board and the CD mechanism as- CD mechanism board sembly. CN606 Caution: Before disconnecting the card wire from connector CN607 CN607 the CD mechanism board and from CD pickup board, solder...
Page 12
3.1.5 Removing the CD mechanism (See Fig.14) • Prior to performing the following procedure, remove the front CD mechanism panel assembly, the main board, the CD mechanism assembly and the CD mechanism board. (1) Remove the four screws J attaching the CD mechanism. CD mechanism assembly Fig.14 3.1.6 Removing the headphone board/ AUX board...
Page 13
3.1.7 Remove the LCD board (See Fig.16, 17) • Prior to performing the following procedure, remove the front panel assembly, the main board and the CD mechanism as- Front panel assembly sembly. (1) From the front panel, pull out the volume knob and remove the nut and the washer.
Page 14
3.1.8 Removing the cassette mechanism assembly (See Fig.18, 19) • Prior to performing the following procedure, remove the front panel assembly and the main board. PUSH OPEN (1) Push ‘PUSH OPEN’ on the front panel to open the cassette door. (2) Remove the screw P attaching the bracket of the cassette mechanism assembly.
Page 15
3.1.9 Removing the heat sink/power board (See Fig.20 to 27) • Prior to performing the following procedure, remove the front panel assembly. Power unit section (1) From the bottom of the rear cover, peel off the tape attach- ing the wire extending from the power board and remove the earth plate which is attached with the double-sided tape.
Page 16
Holder Heat sink Heat sink Power board Fig.25 Band Power board Fig.23 Heat sink Heat sink Power board Power board Unsolder Band Fig.26 Band Bracket Joint f Holder Power board Power board Unsolder Band Unsolder Fig.24 Fig.27 1-16 (No.MB297)
Page 17
3.1.10 Removing the power transformer assembly/voltage selector (See Fig.28, 29) • Prior to performing the following procedure, remove the front panel assembly and the power unit section. Power trnsfomer assembly (1) Remove the four screws E’ attaching the power transform- er assembly.
SECTION 4 ADJUSTMENT Measurement Instruments Required for Adjustment (1) Low frequency oscillator This oscillator should have a capacity to output 0dBs to 600Ω at an oscillation frequency of 50Hz-20kHz. (2) Attenuator impedance : 600Ω (3) Electronic voltmeter (4) Distortion meter (5) Frequency counter (6) Wow &...
Page 19
Cassette amplifier section Item Measuring condition Check and adjustment procedure Standard value Adjusting part Head azimuth Test tape:VT703L 1.Play back the test tape VT703L. Output level: Head azimuth adjustment Signal output Within +/-2 dB of adjusting 2.Adjust the head azimuth adjusting screw so that terminal:PHONES maximum output screw (to be...
SECTION 5 TROUBLESHOOTING Circuit Symptom Cause and Remedy General No sound Defective earphone jack: Replace the earphone jack. Defect in IC801 Check voltages. Replace if necessary. Defect in IC301 Check voltages. Replace if necessary. No sound,weak sound Defect in IF T103: (Low sensitivity) Check resistance, voltage, and current.
Page 22
Victor Company of Japan, Limited AV & MULTIMEDIA COMPANY AUDIO/VIDEO SYSTEMS CATEGORY 10-1,1chome,Ohwatari-machi,Maebashi-city,371-8543,Japan (No.MB297) Printed in Japan...
Page 23
SCHEMATIC DIAGRAMS MICRO COMPONENT SYSTEM UX-H300,UX-H330,UX-H350 CD-ROM No.SML200407 UX-H300 Area suffix US ------------------------ Singapore UT ---------------------------- Taiwan UW ----------- Brazil,Mexico,Peru UX-H330 Area suffix UT ---------------------------- Taiwan UW ----------- Brazil,Mexico,Peru UX-H350 Area suffix UJ ---------------------- U.S.Military Contents Wiring diagram Block diagram...
Page 24
In regard with component parts appearing on the silk-screen printed side (parts side) of the PWB diagrams, the parts that are printed over with black such as the resistor ( diode ( ) and ICP ( ) or identified by the " " mark nearby are critical for safety.
Page 34
Victor Company of Japan, Limited AV & MULTIMEDIA COMPANY AUDIO/VIDEO SYSTEMS CATEGORY 10-1,1chome,Ohwatari-machi,Maebashi-city,371-8543,Japan Printed in Japan (No.MB297SCH)
PARTS LIST [ UX-H300 ] [ UX-H330 ] [ UX-H350 ] * All printed circuit boards and its assemblies are not available as service parts. UX-H300 Area suffix US ---------------------- Singapore UT --------------------------- Taiwan UW ---------- Brazil,Mexico,Peru UX-H330 Area suffix...
Exploded view of general assembly and parts list Block No. FM ANT a r d F901 Display board F902 Power board Phone board LED board...
Page 37
Block No. FM ANT board a r d F901 Display board F902 Power board board LED board CD board AUX board...
Page 38
General Assembly Block No. [M][1][M][M] Symbol No. Part No. Part Name Description Local OW66-00300-21 CD DOOR OW39-04200-80 METAL COVER OW97-09019-80 P.C.MAGNET OW49-00300-12 STABILIZER RING OW55-09019-80 FELT OW55-00141-80 NSX01-050 OW36-00003-80 EJECT SPRING OW16-10101-81 CD DOOR SWITCH DLS-02-1 OW36-00300-10 CD DOOR SPRING OW48-00300-16 CD TRAY OW63-00303-81...
Page 39
Symbol No. Part No. Part Name Description Local OW40-92608-11 SCREW M2.6 X 8(x12) OW40-84012-01 SCREW M4 X 12(x4) OW40-93014-01 SCREW M3.0 X 14(x2) OW40-83005-01 SCREW M3 X 5 OW40-92606-01 SCREW M2.6 X 6 OW81-00300-02 LCD SPONGE BLK. OW68-00300-13 COPPER FOIL OW35-40007-80 STEEL NUT OW35-20001-80...
Electrical parts list Main board Symbol No. Part No. Part Name Description Local Block No. [0][1] OW02-30005-80 D706 KL-3M4 BLUE Symbol No. Part No. Part Name Description Local C101 OW05-70103-10 C CAPACITOR 0.01mF C102 OW05-70102-10 C CAPACITOR 0.001mF IC101 TA2149BFN OW03-02149-01...
Page 41
Symbol No. Part No. Part Name Description Local Symbol No. Part No. Part Name Description Local C214 OW05-73820-05 C CAPACITOR 82pF C406 OW06-75225-20 E CAPACITOR 2.2mF 50V C215 OW05-73182-00 C CAPACITOR 1800pF C407 OW05-73101-05 C CAPACITOR 100pF C216 OW05-73182-00 C CAPACITOR 1800pF...
Page 42
Symbol No. Part No. Part Name Description Local Symbol No. Part No. Part Name Description Local R152 OW07-75102-06 C RESISTOR 1K 1/16W R306 OW07-75222-06 C RESISTOR 2.2K 1/16W R153 OW07-75102-06 C RESISTOR 1K 1/16W R307 OW07-75273-06 C RESISTOR 27K 1/16W R154 OW07-75103-06...
Power board Symbol No. Part No. Part Name Description Local Block No. [0][2] L301 OW08-04344-81 FERRITE COIL L302 OW08-04344-81 FERRITE COIL Symbol No. Part No. Part Name Description Local L303 OW08-04344-81 FERRITE COIL L304 OW09-70222-83T COIL 220mH L401 OW08-04344-81 FERRITE COIL ...
Display board Symbol No. Part No. Part Name Description Local Block No. [0][3] R744 OW07-75103-06 C RESISTOR 10K 1/16W Symbol No. Part No. Part Name Description Local R745 OW07-75103-06 C RESISTOR 10K 1/16W R746 OW07-75103-06 C RESISTOR 10K 1/16W R747 OW07-75103-06 C RESISTOR...
Page 45
Symbol No. Part No. Part Name Description Local Symbol No. Part No. Part Name Description Local XXXXX OW84-00003-80 CABLE TIE 4 UL C638 OW05-73104-00 C CAPACITOR 0.1mF XXXXX OW84-00005-80 CABLE TIE 6.5 UL C639 OW05-73222-00 C CAPACITOR 2200pF Z702 8.2V0.5W Z DIODE...
Page 46
Symbol No. Part No. Part Name Description Local Symbol No. Part No. Part Name Description Local R608 OW07-75472-06 C RESISTOR 4.7K 1/16W L602 OW08-01122-00 FERRITE BEADS RH03509ST-B246 R609 OW07-75472-06 C RESISTOR 4.7K 1/16W L604 OW08-01122-00 FERRITE BEADS RH03509ST-B246 R610 OW07-75472-06 C RESISTOR...